INSTALLATION STEPS:
STEP FIVE : Install The Door Slab
Once the slab has been installed and operates smoothly, locate the (2) anti-jump bars at the top of the Wall Mount. Rotate each 90 degrees to extend over the Top Track. Tighten each with a screwdriver. This step is critical to ensure the safe operation of your rolling door. The correct positioning of these anti-jump bars ensures that the door cannot jump off the top track and disengage from the Wall Mount and the wall. B. Secure -
(L) Anti-Jump Bar
(R) Anti-Jump Bar
Wall Mount A
(R) Anti-Jump Bar
(L) Anti-Jump Bar
Wall Mount A
For Minimally Uneven Floor Surface - ADJUSTMENT SCREW
Anti-Jump Bars
Slight adjustment may be required for the rollers of the Wall Mount. With a Philips screwdriver the wheel as- sembly can be raised 1/4” in height accommodating most floor conditions. The adjustable roller assembly has a fixed maximum distance between the rollers and the anti-jump bars. This is a safety feature
1/4”
Soft-Close Engage
Wall Mount A
Adjustment Screw
and should not be altered in any manner. If the slab moves smoothly in the open and closed positions then no adjustment is needed. Turning the screw clockwise raises the roller assembly. Adjust the roller assembly as needed until the door moves smoothly in both the open and closed positions.
DISCLAIMER: The weight of the Door Slab is carried by the Wheel Assembly in the Bottom Track. The Wall Mount is only designed to be a guide and to keep the door slab in an upright position. Altering the anti-jump bars or improper use may result in damage, bodily harm or death.
21
Visual representations are not to scale.
Powered by FlippingBook