BarnCraft Invisible Hardware Instructions

11 5 2

ma invisibile brevettato per porte muro con Tecnologia Fluid

INVISIBLE HARDWARE INSTRUCTIONS

5. POSITIONING THE SOFT STOP AT TOP OF DOOR

Growth is based on respect, protection is a duty. / La crescita si basa sul rispetto, proteggere è un dovere.

11 6

191

11 6

11 9

11 10

11 7

11 8

4

a crescita si basa sul rispetto, proteggere è un dovere.

181 After the track is installed, the soft stop hardware and wall rollers can be slid into the track. With the provided Allen wrench loosen the set screws on the soft stop hardware, and fit into place at ends of track. The soft stop hardware is not handed and will need to be positioned accordingly. The track will not engage if not oriented correctly. 132 11 6

The wall rollers will then need to be slid into the track, one at each end. The set screw will need to be loosened and the rolls will only engage the track in the correct side and orientation. The wall rollers and soft stop hardware should still be loose but fit into the slot of the track. 134 11 9

The two end caps can now be installed at both ends. The end caps will fit on either end of the track. Notice on the back side of the end cap a sleeve at the bottom and two circles at the top. The sleeve slides down over the tooth on the base of the roll and one of the circles fits into the top radius edge of the track. Once in place, the rolls can be tightened using the Allen wrench. Next, slide the soft stop hardware against the roll and tighten using the Allen wrench. 11 10

132

134

M MAGIC 2 FLUID 6983 REV. 00

X

134

132

and invisible sliding doors system with Fluid Technology ma invisibile brevettato per porte muro con Tecnologia Fluid

15

15

6. INSTALLING FLOOR ROLLERS AND GUIDE AT BOTTOM OF DOOR

To break or remove - Rompere o sfilare

X

At the bottom of the door, pockets for the floor rollers and a slot for the floor guide need to be machined into the bottom edge of the door. See dimension drawings below. *NOTE: If you order a door from GlassCraft, this machining has been done for you, and the hardware has been installed into the bottom of the door. Wrong positioning - Posizionamento scorre

101

TOP VIEW OF BOTTOM DOOR

TOP VIEW OF BOTTOM DOOR

X

15

2 15/16”

1/8”

2 15/16”

1/8”

2 15/16”

1/8”

2 15/16”

1/8”

1/2”

Right positioning - Posizionamento Corret

1/2”

15/16”

15/16”

3/16”

3/16”

To break or remove - Rompere o sfilare

2 3/8” FOR TRACK

2 3/8” FOR TRACK

TRACK INSERT

TRACK INSERT

TRACK INSERT

TRACK INSERT

X

Wrong positioning - Posizionamento scorretto

La crescita si basa sul rispetto, proteggere è un dovere.

Right positioning - Posizionamento Corretto

181

DOOR

DOOR

X

MACHINED AT 1 3/16” FROM BOTTOM OF DOOR

MACHINED AT 1 3/16” FROM BOTTOM OF DOOR

SIDE VIEW OF SLOT

SIDE VIEW OF SLOT

Insert rolls into pocket and screw in place, pre-drill holes in the door for the mounting screws. Once both sets of rolls have been installed, measure the inside distance between both rolls. Locate and cut the guide liner to the measured size and fit into the slot.

101

2002 Brittmoore Rd. Houston,TX 77043 | 713-690-8282 | orderentry@glasscraft.net | glasscraft.com

4

X

Powered by