BarnCraft Invisible Hardware Instructions

ART. 2851

ART. 2850

ART. 2851

INVISIBLE HARDWARE INSTRUCTIONS

= L-6 = L-16

A B

3

= L-6 = L-16

A B

= L-6 = L-16

A B

3

3

3

3

L-155

74

74

7. INSTALLING FLOOR GUIDE

Place masking tape down on the floor along the edge of the door opening and wall.

ART. 2851

ART. 2850

ART. 2851 Determine the leading edge of the door in the open position. Make a mark on the floor on the taped off area with a pencil.

ART. 2850

ART. 2851

ART. 2851

ART. 2850

ART. 2851

ART. 2858 From the leading edge of the door mark, measure back 3-1/8” and mark location on the tape with a pencil. This mark is the front edge location for the spine (point) of the floor guide. ART. 121

ART. 2858

74 Place floor guide on floor at marked locations and then mark for the floor guide holes. Drill and mount accordingly. L-155

74

L-155

74

74

L-155

74

Next determine the distance off the wall to the center of the slot in the bottom of the door. This measurement should be the plumb location of the slab when hung on the roller hardware. Mark with pencil.

ART. 2858

ART. 121

ART. 2858

ART. 121

ART. 2858

ART. 2858

ART. 121

ART. 2858

11 5 2

DOOR

1

11 5 2

1

11 5 2

11 5 2

DOOR LEADING EDGE

PLUM FROM WALL

FLOOR GUIDE SPINE

STANDARD

3 1/8”

*NOTE: Depending on the floor and sub-floor material, additional anchors may be required for this process and will have to be sourced locally.

8. INSTALLING TROLLEY ON THE WALL

Locate the position on the wall where trolley is to be located. Verify if internal blocking is present in this location. If not, then depending on wall material use appropriate wall anchors suitable for the weight of the door. Additional anchors may be required for this process and will have to be sourced locally. Using the height of the door add the 3/8” for the floor space allowance, this is the total height dimension. Then subtract 1-1/16” from the total height dimension. This measurement is to the bottom of the trolley. From the floor mark this dimension on the wall and use a level to draw a level line. For the edge application, follow the edge of the opening and add 1/8” this is the edge of the trolley. This 1/8” space allows for the thickness of the end cap on the track. Now the bottom and the edge of the trolley are located. Position the trolley on the wall and mark the four slotted anchor holes. Install the appropriate anchors and install the roller hardware on the wall.

3

4 4

4

3

4

1

For the overhang application, follow the edge of the opening this is the center of the trolley. Now the bottom and the center of the trolley are located. Position the trolley on the wall and mark the four slotted anchor holes. Install the appropriate anchors and install the roller hardware on the wall.

*NOTE: Refer to Step 2A & Step 2B

11 5

11 6

11 6

1

11 5

11 6

11 6

2002 Brittmoore Rd. Houston,TX 77043 | 713-690-8282 | orderentry@glasscraft.net | glasscraft.com

5

Powered by