INSTALLIATION GUIDE DesignCra Steel Interior Door
INSTALLING THE DOOR HANDLES 8
7. Secure Handles
8. Install Standoff Screws
9. Secure To Spindle
10. Test Handle Operation
Now secure the handles together.
Insert the two standoff screws from the interior side & tighten them into the standoffs. Use a screwdriver. Repeat for the second fastener.
Install the handle set screw. Tighten the set screw to secure the handle to the spindle.
Test both handles for proper operation.
INSTALLING THE COVER STRIPS 9
1. Trim excess shims below the steel frame. 2. Measure and trim the top and both vertical cover strips to fit as needed. 3. Clean the frame and jamb surfaces to remove dust and debris. 4. Remove the backing, align the top horizontal strip, and press firmly into place. 5. Remove the backing, align both vertical strips beneath the top strip, and press firmly into place. 6. Apply even pressure along all three strips and confir they are secure and flush. Installation is complete.
1. Trim Excess Shims
2. Measure & Trim Cover Strips
Trim excess shims below the steel frame.
Mark and trim the top and both vertical strips to fit as needed.
6. Final Check The New Door!
3. Clean Surfaces
4. Position & Apply Top Strip
5. Apply Vertical Strips
Clean the frame and jamb surfaces to remove dust and debris.
Remove the backing, align the top horizontal strip, and press firmly into place.
Remove the backing, align both vertical strips beneath the top strip, and press firmly into place.
Apply pressure along all three strips and confirm they are secure and flush. Installation is complete!
Enjoy Your DesignCraft Steel Interior Door!
8
Powered by FlippingBook